HOW TO TROUBLESHOOT AND ALSO FIX AN ELECTRIC WATER HEATER

How to Troubleshoot and also Fix an Electric Water Heater

How to Troubleshoot and also Fix an Electric Water Heater

Blog Article

Call Today

Each person may have their personal conception involving No Hot Water — Water Heater Repair.



Lots of contemporary homes make use of an electrical hot water heater for their heater, because of its ease and also simplicity of use. However, just like any other electric home appliances, problems might develop with its usage, unexpectedly. It can be actually irritating to get up to a cold shower as opposed to a warm one or having your bath with water that isn't warm sufficient or even also warm. Whatever the case might be, hot water heater problems can be fairly stressful. Fortunately, we have actually made a listing of possible remedies to your water heater concerns. There are a variety of factors that can trigger many of these problems, maybe an issue with the power supply, the electric burner, or the thermostat. Before doing anything, ensure you switch off the main power supply for safety and security. Whatever the problem is, getting it taken care of should not present way too much of a problem if you adhere to these steps:

Call An Expert:


If after changing all defective components and resetting your temperature, the hot water heater still isn't working, you may require to contact a professional plumber for a specialist opinion. The issue with your heating system could be that the hot and cold taps have actually been switched over or it may be undersized for the amount of warm water required in your home. Whatever the situation might be, a professional plumber would assist address the problem.

Inspect Your Power Supply:


As fundamental as this might seem, it is very needed. Without ample power, your water heater will not work. So the first thing to do when your water unexpectedly retires is to validate that it isn't a power problem. Check if the fuse is burnt out or the breaker tripped. If the circuit breaker is the concern, simply turn it on and off once more. Replace any type of busted or damaged fuse. Test the home appliance with power after these adjustments to see if it's now working.

Inspect Your Thermostat:


If your hot water heater still isn't functioning or the water coming out isn't hot sufficient, you might require to check the temperature setups on your top thermostat. Make certain the circuit breaker is switched off prior to doing anything. Open up the accessibility panel and press the red button for temperature level reset over the thermostat. This need to help heat the water. Turn the circuit breaker back on as well as examine if the trouble has been dealt with.

Inspect the Burner in the Hot Water Heater:


If it's not a power trouble, after that try checking out your heating element if it is still working. Evaluate each of your heating elements to make sure the issue isn't with any one of them. If any one of them is malfunctioning, change that component and then check whether the hot water is back on.

Conclusion


Water heater problems are not always major. A number of them are because of minor problems like a blown fuse or worn-out heating element. Replacing the defective parts ought to work. Nevertheless, if you are still not able to fix the problem, give a call to your nearest plumber ahead to get it taken care of.


8 possible reasons why you have no Hot Water


Along with streaming Netflix and having light flood a room when we flick a switch, having hot water flow from our taps and showerheads whenever we want is an oft-overlooked modern miracle of homeownership. That's why, when that flow goes cold, it can be shocking — and not just in a "Wow, that's freezing" kind of way while you're in the shower.


Water Leak


Before hot water reaches your taps and showerheads, it needs to spend some time in your water heater. This appliance, which can be either gas- or electric-powered, takes the cold water that enters your home from your well or utility company and cooks it until it gets hot. It's akin to an electric tea kettle.



Obviously, if your water heater is leaking, it will never fill with water so it won't have anything to warm. To see if this is the case, simply examine the area around the water heater to see if it is wet. If so, you'll likely need to replace the unit, but you can also call in a pro for a second opinion and to see if it is fixable. Sometimes leaks can happen around fixtures on the water heater, and if so, the solution might be as simple as replacing them.


Gas Heater: Gas Leak


If your hot water is fueled by natural gas and there is a leak in the supply line or where the line enters the tank, the appliance won't have the power it needs to heat up your water. The result is not only inconvenient, but it can be extremely dangerous as well. If you smell gas when you investigate your water heater, call your gas utility company immediately and report it as an emergency. It might also be prudent to leave your home until a repair person from the company arrives. Your utility company will usually fix any kind of gas leak. However, in terms of getting your water heater working again, you'll need to relight the pilot and wait a while to see if it is functioning properly. You can call in a water heater specialist or plumber to help with this.


Gas Heater: Pilot Light Problems


There are two other issues with gas-powered water heaters that can lead to a loss of hot water. The first is a pilot light that's blown out. The pilot light is the source of a constant flame inside your water heater. When the heater determines the need to heat up the water it is holding, it will open a valve that will cause gas to flow over the pilot light and cause it to ignite. To see if your pilot light is functioning, there is usually a small window in the front of the water heater. If you can't see a flame, remove the access panel and see if that helps you locate it. If there is still no flame, you'll need to relight it in accordance with the manufacturer's instructions.



Your pilot light should burn with a bright blue flame. If not, make sure there are no drafts affecting it, which could keep it from functioning properly. If the flame looks yellow, it might be a sign of the presence of carbon monoxide, which spells trouble and needs to be looked at right away by a technician.


Gas Heater: Faulty Thermocouple


The second reason why a gas-powered water heater might fail is a faulty thermocouple. This is a small probe that should sit in the pilot light flame. Its purpose is to stop the flow of gas if it senses that the pilot light is out. Sometimes, these probes get knocked off track, so make sure it is directly in the flame. They can also get a buildup on them that prevents their function, so try cleaning yours off with some steel wool or fine-grit sandpaper. If your pilot light won't stay lit and you've tried these steps to fix the thermocouple, it is likely faulty and needs to be replaced. Call a technician.


Electric Heater: Breaker Blues


Electric water heaters don't have pilot lights, because there is no gas to burn in order to heat up the water. Instead, they do their magic through the use of (naturally) electricity. But that's not to say things can't go wrong with them. If your electric water heater isn't working properly, there's a good chance that a breaker was tripped that supplies the appliance power. Check your breaker box and flip any breakers that have switched to the off position back on. If it trips again, then there might be a fault in the water heater, and you'll want to call in a pro to have a look.


Electric Heater: Reaching The Limit


If the breaker is fine, check to see if the high-temperature limit has switched off on the water heater itself. To do so, first turn off the breaker to the unit. Then remove the service panel and press the red button you'll find there. This is the limit switch, and resetting it could solve your problem. To check, replace the panel, turn the breaker back on and listen to see if the water heater is functioning again.


Electric Heater: Heating Element


If these steps don't fix the issue, then you might have a failed heating element, which will need to be replaced. Unless you are comfortable with such repairs, calling in a technician might make the most sense.

https://www.homeserve.com/en-us/blog/home-improvement/no-water-heater/


No Hot Water — Water Heater Repair

I was made aware of that report on How to Troubleshoot and Repair an Electric Water Heater from someone on a different domain. Sharing is caring. Helping people is fun. Thanks so much for going through it.




Book Your Appointment

Report this page